Craftsman 580.752000 - Manual (Page 13)

6. Reinstall orifice and in-line filter into nozzle
extension. DO NOT overtighten orifice with alien
wrench.
7. Reconnect nozzle extension to spray gun.
8. Reconnect water supply, turn on water, and start
engine.
9. Test pressure washer by operating nozzle in high
and low positions.
0-Ring IVIaintenance
Purchase an 0-Ring Repair Kit, item number 7175118,
at your local Sears or by calling 1-800-386-PART or
online at www.seai^.ojm. It is not Included with the
pressure washer. This kit includes replacement o-rings,
rubber washer and water inlet filter. Refer to the
Instruction sheet provided in the kit to service your unit s
0- rings.
Pump IVIaintenance
Changing Pump Oil
Change oil every 60 hours or once yearly, whichever
occurs first.
NOTE; You must purchase a premeasured bottle of
pump oil, item number 190586GS, by calling
1- 800-386-PART or online at www.sears.com.
Change pump oil as follows;
1. Drain engine oil and fuel from pressure washer.
2. Use a 8mm alien wrench to remove black pump
oil cap between high pressure outlet and garden
hose inlet.
Oil Cap
3.
4.
5.
6.
Tilt pressure washer to drain oil into an approved
container until it drips slowly from pump.
Tilt pressure washer in opposite direction and
empty premeasured pump oil bottle into same
opening (a small funnel may be helpful).
Install black pump oil cap and tighten firmly.
Set pressure washer in upright position. Add fuel
and engine oil.
ENGINE IVIAINTENANCE
Checking Oil Level
Oil level should be checked prior to each use or at least
every 8 hours of operation. Keep oil level maintained.
Changing Oil
Change engine oil after the first 6 hours and every
50 hours thereafter. If you are using your pressure
washer under extremely dirty or dusty conditions, or in
extremely hot weather, change oil more often.
m
CAUTION
Avoid prolonged or repeated skin contact with used
motor oil.
Used: motor oil has been shown to cause: skin cancer in
certain laboratory animals. 1111111111111111111
T hproi] ghiy wash i exposed i areas with i soap i and i water.:
KEEP OUT OF REACH OF CHILDREN.
DON'T POLLUTE. CONSERVE
RESOURCES. RETURN USED OIL TO
COLLECTION CENTERS.
Change oil while engine is still warm from running,
as follows:
1. Drain fuel tank by running pressure washer until
fuel lank is empty.
2. Disconnect spark plug wire and keep it away from
spark plug.
3. Clean area around oil fill, remove oil fill
cap/dipstick. Wipe dipstick clean.
4. Tip your pressure washer to drain oil from oil fill
into a suitable container making sure you tip your
unit away from spark plug and air cleaner. When
crankcase is empty, return pressure washer to
upright position.
5. Wipe dipstick clean, insert it into oil fill hole and
tighten securely, remove dipstick. Add
recommended oil up to “Full " mark on dipstick.
Pour slowly. Wipe dipstick clean each lime oil
level is checked. DO NOT overfill.
6. Install oil fill plug and dipstick, tighten securely.
7. Wipe up any remaining oil.
8. Reconnect spark plug wire to spark plug.
13