A warning, Replacing fuse, Maintenance schedule – Craftsman 247.887210 User Manual

Page 19: Awarning, Service and maintenance

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SERVICE AND MAINTENANCE

IMPORTANT: Always plug charger lead Into battery pack lead first,
and then Insert battery charger plug Into 120 volt standard household

outlet. Follow this order of action every time you charge the battery.

A WARNING

[ Use only the battery charger supplied with this mower._______ |

Replacing Fuse

The electric starter circuit and battery are protected by a 40 ampere
fuse. If the fuse burns out, the electric starter will not operate. If the
unit fails to start with the electric starter, perform the following steps to
check the fuse inside the battery housing:

1. Open the battery cover as described in Replacing Battery. See

Figure 19.

2.

Remove fuse from socket and inspect as shown in Figure 22. If it
is burned out, replace with standard automotive 40 ampere fuse.

3. Carefully place wiring back into housing, close battery cover, and

fold upper handle back into place.

NOTE: The engine can be started manually it the fuse bums out.

V

Figure 22

MAINTENANCE SCHEDULE

AWARNING

Before performing any type of maintenance/service, disengage all

controls and stop the engine. Wait until all moving parts have come to
a complete stop. Disconnect spark plug wire and ground it against the
engine to prevent unintended starting.

Follow the maintenance schedule given below. This chart describes
service guidelines only. Use the Service Log column to keep track of

completed maintenance tasks. To locate

the nearest

Sears Service

Center or to schedule service, simply contact Sears at
1-800-4-MY-HOME®.

Interval

Item

Service

Service Log

Each Use

1. Engine oil level

2.

Loose or missing hardware

3.

Unit and engine.

1. Check

2. Tighten or replace

3. Clean

1st 5-8 hours

1. Engine oil

1. Change

25 hours

1

.

Air cleaner t

2. Control linkages/pivots and wheels

1. Clean or replace

2.

Lube with light oil

50 hours

1

. Engine oil tt

1. Change

Annually or 100 hours

1. Spark plug

1. Clean, replace, re-gap

Before Storage

1. Fuel system

1. Run engine until it stops from lack of

fuel or add a stabilizer to the gas in the
tank.

t Clean more often under dusty conditions or when airborne debris is present. Replace air cleaner it very dirty,

tt Change oil every 25 hours whem operating the engine under heavy load or in high temperatures.

19

Advertising