To replace mower blade drive belt (see fig. 25), To adjust brake (see fig, 26), To replace motion drive belt (see fig. 27) – Craftsman 917.259172 User Manual

Page 22: Service ais!d adjustments

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

SERVICE AiS!D ADJUSTMENTS

TO REPLACE MOWER BLADE DRIVE BELT

(See Fig. 25)

The mower blade drive belt may be replaced without tools.

Park the tractor on level surface. Engage parking brake.

BELT REMOVAL -

® Remove mower from tractor (See ‘TO REMOVE

MOWER” in this section of this manual).

» Work belt off both mandrel pulleys and idler pulleys.

» Pull belt away from mower.

BELT INSTALLATION -

<■ Install new belt in reverse order of removal,

» Make sure belt is in all pulley grooves and inside all belt

guides.

« Install mower in reverse order of removal instructions.

TO ADJUST BRAKE (See Fig, 26)

Your tractor is equipped with an adjustable brake system
which is mounted on the side of the transaxle.

If tractor requires more than six (6) feet stopping distance

at high speed in highest gear, then brake must be adjusted.

» Depress clutch/brake pedal and engage parking brake.

« Measure distance between brake operating arm and

nut “A" on brake rod.

»

If distance is other than 1 "3/4", loosen jam nut and turn

nut “A” until distance becomes 1 -3/4". Retighten jam

nut against nut “A”.

»

Road test tractor for proper stopping distance as stated

above. Readjust if necessary. If stopping distance is
still greater than six (6) feet in highest gear, further

maintenance is necessary. Contact your nearest au­

thorized service center/department.

TO REPLACE MOTION DRIVE BELT

(See Fig. 27)

Park the tractor on level surface. Engage parking brake.
For assistance, there is a belt installation guide decal on
bottom side of left footrest,

Remove mower (See ‘TO REMOVE MOWER" in this

section of this manual)

■> Remove upper belt keeper.

<• Remove belt from stationary idler and clutching idler.

■> Pull belt slack toward rear of tractor. Carefully remove

belt upwards from transmission input pulley and over
cooling fan blades.

• Puli belt toward front of tractor and remove downward

from around engine pulley.

» Install new belt by reversing above procedure.

IMPORTANT:

MAKE SURE UPPER BELT KEEPER IS

POSITIONED PROPERLY BETWEEN LOCATOR TABS.

Advertising