Operation – Craftsman 315.284620 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
OPERATION
The blade depth should be set so that the outer points of
the blade are higher than the workpiece by approximately
1/8 In, to 1/4 In, but the lowest points (gullets) are below
the top surface.
■ Raise the blade by turning the helght/bevel adjusting
handwheel clockwise or lower It by turning the hand
wheel counterclockwise.
GULLET
TO CHANGE BLADE DEPTH
See Figure 28.
Fig. 28
TO CHANGE BLADE ANGLE (BEVEL)
See Figured 29 - 30.
NOTE: A 90° cut has a 0° bevel and a 45° cut has a 45°
bevel.
■ Loosen bevel control by pulling the bevel locking lever
all the way to the right.
■ Adjust the bevel angle by pushing the wheel In toward
the saw then turning It. Turning the wheel counter
clockwise Increases the angle of the blade, bringing It
closer to 45°. Turning It clockwise decreases the angle,
bringing the blade closer to 90°.
■ Tighten bevel control by pushing the bevel lock lever to
the left.
TO DECREASE
ANGLE
TO ADJUST THE BEVEL INDICATOR
See Figure 30.
If the bevel Indicator Is not at zero when the saw blade
Is at 90°, adjust the Indicator by loosening the screw and
setting It at 0° on the bevel scale. RetIghten the screw.
BEVEL
LOCKING
LEVER
7T r
HEIGHT/BEVEL
Fig. 29
Fig. 30
26