Troubleshooting, Troubleshooting -40, Accessories – Craftsman 315.284620 User Manual
Page 39
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ACCESSORIES
J
The following recommended accessories are currently available at retail stores:
089037008711 Dado Throat Plate with Special Washer
■A. WARNING: Current attachments and accessories available for use with this tool are listed above. Do not use
any attachments or accessories not recommended by the manufacturer of this tool. The use of attachments or
accessories not recommended can result in serious personal injury.
TROUBLESHOOTING
PROBLEM
CAUSE
SOLUTION
Excess vibration.
Blade is out of balance.
Blade is damaged.
Saw is not mounted securely.
Work surface is uneven.
Blade is warped.
Replace blade.
Replace blade.
Tighten all hardware.
Reposition on flat surface.
Adjust legs of optional stand.
Check saw blade installation. Replace blade if
necessary.
Rip fence does not move
smoothly.
Rip fence not mounted correctly.
Rails are dirty or sticky.
Clamp screw is out of adjustment.
Remount the rip fence.
Clean and wax rails.
Adjust clamp screw counterclockwise.
Rip fence does not lock at
rear.
Clamp screw is out of adjustment.
Adjust clamp screw clockwise.
Cutting binds or burns work.
Blade is dull.
Blade is heeling.
Work is fed too fast.
Rip fence is misaligned.
Wood is warped.
Spreader is out of alignment.
Replace or sharpen blade.
See page 29 on "Heeling the Blade".
Slow the feed rate.
Align the rip fence.
Replace the wood. Always cut with convex
side to table surface.
See “To check and align the spreader/riving knife
and saw blade” in the Assembly section.
Wood edges away from rip
fence when ripping.
Blade not properly sharpened or set. Resharpen or set blade.
39