Installation step 7, Installation step 8, Install the lights and the lenses – Craftsman 139.53664SRT2 User Manual

Page 19: Attach the emergency release rope and handle

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

6. Attach the User Safety Instruction label to the wall

near the door control, and the Maintenance

Instruction label in a prominent location on the

inside of the garage door.

Page 32 explains how to use the door control.

Do NOT connect the power and operate the
opener at this time.

The trolley will travel to the

full

open

position but will not return to the

dose

position

until

the

sensor

beam

is

connected and properly aligned.

See

Safety

Reversing

Sensor

instructions

beginning on page 21.

Installation Step 7

Install the Lights and the Lenses

Install the lights:

• Install a 75 watt maximum light bulb in each

socket. The lights will turn ON and remain lit for
approximately 4-1/2 minutes when power is
connected. Then the lights will turn OFF.

• If the bulbs burn out prematurely due to vibration,

replace them with standard neck "Garage Door
Opener" bulbs.

Install the lenses:

• Apply slight pressure on the sides of each lens

and slide the tabs into the slots in the side panels.

• For convenience, the lenses may be instalied

after Adjustment Step 4 on page 30.

• Reverse the procedure to remove the lenses.

75 Watt Max.

Lens

Light Bulb

Guide

Lens

Tab

Installation Step 8

Attach the Emergency

Release Rope and Handle

* •

• Thread one end of the rope through the hole in

the top of the red handle so "NOTICE" reads right

side up as shown. Secure with an overhand knot.

The knot should be at least 1" from the end of
the rope to prevent slipping.

• Thread the other end of the rope through the hole

in the release arm of the outer trolley.

• Adjust rope length so the handle is 6 feet above

the floor. Secure with an overhand knot.

If it is necessary to cut the rope, heat seal the

cut end with a match or lighter to prevent

unraveling.

Do not use the red handle to pull the door

open or closed.

The rope knot couid become

untied and you couid fall.

Use the emergency

release only to disengage the trolley and, if
possible, only when the door is closed.

Garage doors are heavy. If the door is open
when the handle is pulled, the door could
close

inadvertently if it is not properly

balanced. Serious injury may result to persons
under the door. Make sure the doorway is clear
of persons and obstructions before pulling
handle when door is open.

Overhand

Knot

Trolley

— Trolley

Release Arm

Overhand

Knot

Emergency

Release Handle

19

Advertising