Craftsman 580.762010 - Manual (Page 4)

ASSEMBLY
CARTON CONTENTS
The following parts are shipped loose with your pressure
washer. Before assembling, become familiar with each
piece.
Check all carton contents against the listing below:
Main Unit;
• Pressure Washer (w/wheels) and Guide Handle.
• High Pressure Hose
Parts Box:
• Adjustable Nozzle
•Turbo Nozzle
• Spray Gun
• Nozzle Extension
• Wire Form
• Motor Oil
Manual Bag:
• Owner’s Manual
• Nozzle Cleaning Kit
• “0”-Ring Kit
If any parts are missing or damaged, call the Pressure
Washer Helpline at 1-800-222-3136.
HOW TO REMOVE THE HIGH PRESSURE
WASHER FROM CARTON
• Remove parts boxes included with pressure washer.
The high pressure hose is packed in the bottom of the
carton. Remove the hose.
• Slice two comers at handle end of carton, from top to
bottom, so the panel can be folded down flat.
• Raise handle, secure in place with the locking caps
{refer to illustration below) and roll the pressure
washer out the open end of the carton.
For the most part, your Craftsman High Pressure Washer
has been assembled at the factory. You must, however,
attach the wire form, assemble the spray gun and attach
the high pressure hose to the pump and spray gun.
• While facing the rear of the Pressure Washer, insert
the wire support with the longer arm positioned on the
left. From this view the hook should resemble a “J”.
HOW TO SET UP YOUR PRESSURE WASHER
Cut tie wrap on chemical injection tibe. Remove the
chemical injection filter, thread chemical injection tube
through the wire form .
Reinsert the chemical injection filter into tube.