Assembly, Install seat (see fig. 4), Check tire pressure – Craftsman 917.256544 User Manual
Page 8: Check deck levelness, Check for proper position of all belts, Check brake system, Assemble gauge wheels to mower deck (see fig. 5)
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ASSEMBLY
Open battery box door for:
» Inspection for secure connections (to tighten hard
ware).
» Inspection for corrosion.
•
Testing battery.
® Jumping (if required).
•
Periodic charging .
DISCARD
TERyiNAL
PROTECTIVE
CAPS
LOCK
WASHER
FLAT
WASHER
HEX
BOLT
POSITIVE
(RED) CABLE
NECSATIVE
(BLACK) CABLE
FIG. 2
SEAT
PAN
BATTERY -
BOX DOOR
FIG.3
INSTALL SEAT (See Fig. 4)
Adjust seal before tightening adjustment bolt.
•
Remove cardboard packing on seat pan.
•
Place seat on seat pan and assemble shoulder bolt.
® Assemble adjustment bolt, lockwasherandflatwasher
loosely. Do not tighten.
•
Tighten shoulder bolt securely.
•
Lower seal into operating position and sit on seat.
® Slide seat until a comfortable position is reached which
allows you to press dutch/brake pedal all the way
down.
•
.Get off seat without moving its adjusted position.
•
Raise seat and tighten adjustment bolt securely.
CHECK TIRE PRESSURE
The tires on yourtractorwere overinflaled at the factory for
shipping purposes. Correct tire pressure is important for
best cutting performance.
•
Reduce tire pressure to PSI shown in “PRODUCT
SPECIFICATIONS” on page 3 of this manual.
CHECK DECK LEVELNESS
For best cutting results, mower housing should be properly
leveled. See “TO LEVEL MOWER HOUSING" in the
Service and Adjustments section of this manual.
CHECK FOR PROPER POSITION OF ALL
BELTS
'
See the figures that are shown for replacing motion and
mower blade drive belts in the Service and Adjustments
section of this manual. Verify that the belts are routed
correctly.
CHECK BRAKE SYSTEM
After you learn how to operate your tractor, check to see
that the brake is properly adjusted. See 'TO ADJUST
BRAKE" in the Service and Adjustments section of this
manual.
'
ASSEMBLE GAUGE WHEELS TO MOWER
DECK (See Fig. 5)
Assemble gauge wheels with tractor on aflat level surface.
•
Adjust mower to desired cutting height {See ‘TO AD
JUST MOWER CUTTING HEIGHT" in the Operation
section of this manual).
•
With mower in desired height of cut position, gauge
wheels should be assembled so they are slightly off the
ground. Install gauge wheel in appropriate hole with
shoulder bolt, 3/8" washer and 3/8-16 locknut and
tighten securely.
•
Repeat for opposite side installing gauge wheel in
same adjustment hole.
•
8