Cisco 3545 MCU - Manual (Page 21)

2-15
Installation and Upgrade Guide for Cisco Unified Videoconferencing 3545 MCU Releases 5.6 adn 5.7
OL-17013-01
Chapter 2 Installing the Cisco Unified Videoconferencing 3545 MCU
Installing the MCU and EMP
Installing the MCU and EMP
This section describes how to insert the MCU into the Cisco Unified Videoconferencing 3545 chassis.
Before You Begin
• The Cisco Unified Videoconferencing 3545 chassis has four slots. You can install the MCU and the
EMP in any of the slots at the front of the chassis.
• Insert the MCU in the top slot at the front of the Cisco Unified Videoconferencing 3545 chassis to
view status and identification information via the System web user interface.
Warning During this procedure, wear grounding wrist straps to avoid ESD damage to the card. Do not directly
touch the backplane with your hand or any metal tool, or you could shock yourself.
Warning Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning Before working on a system that has an on/off switch, turn OFF the power and unplug the power cord.
Procedure
Step 1 On the front of the chassis, loosen the screws of the blank panel covering the slot into which the MCU
or the EMP module is to be installed.
Step 2 Remove the blank panel.
Step 3 Remove the new MCU or the EMP module from the antistatic bag.
Step 4 Press the red buttons and open the handles of the MCU or the EMP module.
Step 5 Align the edges of the MCU or the EMP module with the chassis guide rails.
Step 6 Slide the MCU or the EMP module into the chassis until it stops (see Figure 2-4 ).
Figure 2-4 Inserting the MCU or the EMP in the Cisco Unified Videoconferencing 3545 Chassis
Step 7 Use even pressure to push the module further into the slot.
157274