Craftsman 358.799380 - Manual (Page 5)

twigs, and bits of paper. Do not vacu­
um stones, gravel, metal, broken
glass, etc,, to avoid severe damage to
the impeller. To avoid the possibility of
electrical shock, do not attempt to vac­
uum water or other liquids.
Never run the unit without the proper
equipment attached. When used asa
vacuum, always install vacuum tubes
and collection bag assembly. Make
sure the collection bag assembly is
completely zipped when unit is run­
ning to avoid flying debris. Use only
recommended attachments.
Avoid situations which could set the
collection bag on fire. Do not vacuum
discarded matches, cigars, cigarettes,
or ash from fireplaces, barbecue pits,
brush piles, etc. To avoid spreading
fire, do not use blower near leaf or
brush fires, fireplaces, barbecue pits,
ashtrays, etc.
Always use the collection bag shoul­
der strap when vacuuming to avoid
loss of control.
• Check air intake openings, elbow
tube, and vacuum tubes frequently, al­
ways with the unit stopped and the
power source disconnected. Keep
vents and tubes free of debris which
can accumulate and restrict proper air
flow. Do not use with any opening
blocked. Keep free of dust, lint, hair
and anything that may reduce airflow.
STANDARDS
This product is listed by Undenwriters
Laboratories, Inc., in accordance with
UL Standard 1017.
If situations occur which are not cov­
ered in this manual, use care and
good judgment. If you need assis­
tance, contact your Sears Service
Center or call 1 -800-235-5878. Fail­
ure to follow all Safety Rules and Pre­
cautions can result in serious injury.
SAVE THESE INSTRUCTIONS
ASSEMBLY
CARTON CONTENTS
Model 358.799380
Blower
Blower Tube
Nozzle
2 Vacuum Tubes
Collection Bag
Examine parts for darrage. Do not use
damaged parts.
NOTE; If you need assistance or find
parts missing or damaged, call
1-800-235-5878.
ASSEMBLY
^WARNING: If received as­
sembled, repeat all steps to ensure
your unit is properly assembled and all
fasteners are secure.
ASSEMBLY INSTRUCTIONS FOR
USING YOUR UNIT AS A BLOWER
NOTE: Assembly Instructions for using
your unit as a vacuum follow this sec­
tion.
ATTACHING THE BLOWER TUBE
AND NOZZLE
If you have already assembled your
unit for use as a vacuum, remove the
vacuum tubes and the collection bag.
• Insert the blower tube into the blower
outlet.
• Twist the blower tube clockwise until
It is firmly seated in the blower outlet.
• Twist the nozzle into the end of the
blower tube until It is firmly seated.
Make sureihe nozzle points upward.
Blower Tube
Nozzle