Craftsman 358.792440 - Manual (Page 6)

NOTE: The tube clamp base has four
spacer tabs attached. These tabs are
provided to adapt this attachment for
use with powerheads that have a 1" di­
ameter upper tube {the tube clamp will
not tighten down securely on the 1" di­
ameter upper tube without using these
spacer tabs). The tabs must be broken
off completely before use and placed
over the screw holes on the clamp base.
These tabs are not needed for power-
heads with a 7/8" upper tube.
HANDLEBAR CLAMP BASE
Spacer Tabs
Spacer Tabs
positioned for use
on 1" diameter
upper tube
1. Place the tube clamp over the upper
tube above the arrow on the safety
decal.
2. Position the clamp base under the
upper tube and align the tube clamp
and clamp base screw holes {use
spacer tabs between tube clamp
and clamp base if necessary to se­
cure clamp, i.e. for 1" diameter up­
per tube).
Handlebar
\iL
POWERHEAD
END
Handlebar Clamp
between arrows on
handlebar decal
Clamp^jSlKtii
Knob
Tube
Clamp
/ f V Arrow on
Safety Decal
ATTACHMENT END
Insert four screws into the screw
holes.
4. Secure tube clamp by tightening
screws with the hex wrench.
5. Position the handlebar as shown,
ensuring the handlebar Is posi­
tioned on the handlebar clamp be­
tween the two arrows on the han­
dlebar decal.
6. Retighten handlebar by turning
clamp knob clockwise until handle­
bar Is secure and stationary In
clamp (damp knob cannot be
overtightened).
SHOULDER STRAP ASSEMBLY
WARNING: Proper shoulder
strap and handlebar adjustments must
be made with the engine completely
stopped before using unit. The shoul­
der strap clamp must be installed as
shown above the handlebar on the up­
per tube (powerhead end of unit).
NOTE: The lower shoulder strap clamp
has two spacer tabs attached. These
tabs are provided to adapt this attach­
ment for use with powerheads that have
a 1" diameter upper tube (the shoulder
strap clamp will not tighten down se­
curely on the 1" diameter upper tube
without using these spacer tabs). The
tabs must be broken off completely be­
fore use and placed over the screw
holes on the lower shoulder strap clamp.
These tabs are not needed for power-
heads with a 7/8" upper tube.
LOWER SHOULDER STRAP
CLAMP
Spacer Tabs
4^
LDER STI
gb|s
4^
-— Spacer Tabs
positioned for use
on 1" diameter
upper tube
1. Place the upper shoulder strap
clamp over the upper tube above
the handlebar.
2. Position the lower shoulder strap
clamp under the upper tube and
align the upper and lower clamp
screw holes (use spacer tabs be­
tween upper and lower clamps if
necessary to secure clamp, i.e. for
1" diameter upper tube).