Service and adjustments – Craftsman 358.351080 User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SERVICE AND ADJUSTMENTS
' Pull out 10" of rope and catch пэре in notch in ttie pulley.
■ Carefully turn the pulley two complete turns clockwise,
keeping the rope against the notch to wind the spring.
While holding the pulley ratchet, pull the excess rope
through the starter rope hole. While holding tension on
the rope, let rope slowly rewind into the housing.
' Reinstall (an housing by aligning the fan housing to the
chassis. Then whiie holding the fan housing against the
chassis, pull the rope handle out until you feel the fan
housing drop into place against the chassis. Slowly, let
the rope rewind into starter housing.
Reinstall the 4 fan housing screws and tighten the 2
cylinder cover screws. Figure 44.
Figure 48
-24