A warning – Craftsman 580.752300 User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
9. Move throttle lever
(A)
to
“Fast”
position, shown as a
rabbit.
10.
Move choke lever
(B)
to
“Closed”
position.
NOTE:
For a warm engine, be sure the choke lever is in the
“Open”
position.
1
1. Move engine switch (C) to
“On”
position.
IMPORTANT: Before starting the pressure washer, be sure
you are wearing adequate safety goggles.
A WARNING
Risk of eye injury.
Spray can splash back or propel objects.
Always wear safety goggles when using this equipment or in
vicinity of where equipment is in use.
Before starting the pressure washer, be sure you are wearing
adequate safety goggles.
NEVER substitute safety glasses for safety goggles.
12. When starting engine, position yourself as
recommended and grasp starter grip handle and pull
slowly until you feel some resistance. Then puli rapidly
to start engine.
A WARNING
%
starter cord kickback (rapid retraction) can result
in bodily injury. Kickback will puli hand and arm
toward engine faster than you can let go.
Broken bones, fractures, bruises, or sprains
could result.
NEVER pull starter cord without first relieving spray gun
pressure.
When starting engine, pull cord slowly until resistance is felt
and then pull rapidly to avoid kickback.
After each starting attempt, where engine fails to run, always
point spray gun in safe direction, press red button and squeeze
spray gun trigger to release high pressure.
Firmly grasp spray gun with both hands when using high
pressure spray to avoid injury when spray gun kicks back.
13. Return recoil starter slowly. DO NOT let rope “snap
back” against starter.
14. When engine starts, slowly move choke lever to
“Open”
position as engine warms. If engine falters, move choke
lever to
“Closed”
position, then to
“Open”
position.
15. If engine fires, but does not continue to run,always point
gun in safe direction, press red botton and squeeze spray
gun trigger to release high pressure. Move choke lever to
“Open”
position, and repeat steps 12 through 14.
16. If engine fails to start after six pulls, move choke lever to
“Open”
position, and repeat steps 12 through 14.
NOTE:
Always keep the throttle lever in the
“Fast”
position
when operating the pressure washer.
10