Sediment cup cleaning – Craftsman 580.752300 User Manual

Page 19

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Spark Arrester Serwice

Your engine is not factory-equipped with a spark arrester. In
some areas, it is illegal to operate an engine without a spark
arrester. Check local laws and regulations. A spark arrester is
available from your nearest Sears service center. If you need
to order a spark arrester, please call 1-800-4-MY-HOME
(469-4663).

The spark arrester must be serviced every 100 hours to keep
it functioning as designed.

If the engine has been running, the muffler will be very hot.

Allow the muffler to cool before servicing the spark arrester.

A WIRNIilG

Ш

Contact with muffler area can result in serious
burns.
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.

DO NOT touch hot parts and AVOID hot exhaust gases.

Allow equipment to cool before touching.

Keep at least 5 feet (152 cm) of clearance on all sides of
pressure washer including overhead.

Code of Federal Regulation (CFR) Title 36 Parks, Forests, and

Public Property require equipment powered by an internal
combustion engine to have a spark arrester, maintained in
effective working order, complying to USDA Forest service
standard 5100-1C or later revision. In the State of California a
spark arrester is required under section 4442 of the California
Public resources code. Other states may have similar laws.

1. Remove the two 8 mm nuts

(A)

and remove muffler (B)

from cylinder.

2.

Remove the three 4 mm screws (C) from exhaust
deflector (D), and remove deflector.

3.

Remove the four 5 mm screws (E) from muffler
protector (F) and remove muffler protector.

4.

Remove 4 mm screws

(G)

from spark arrester

(H)

and

remove spark arrester from muffler.

5.

Use a brush to remove carbon deposits from spark

arrestor screen. Be careful to avoid damaging screen.

IMPORTANT: The spark arrestor screen must be free of
breaks and holes. Replace spark arrestor if it is damaged.

6.

install spark arrestor, muffler protector, exhaust
deflector and muffler in reverse order of disassembly.

Sediment Cup

Cleaning

1. Move fuel valve to

“Off”

position, then remove fuel

sediment cup

(J)

and o-ring

(K).

2.

3.

4.

Wash sediment cup and o-ring in nonflammable solvent.

Dry thoroughly.

Place o-ring in fuel valve and install sediment cup.

Tighten sediment cup securely.

Move fuel valve to

“On”

position and check for leaks.

Replace o-ring if there is any leakage.

19

Advertising