Craftsman 580.752300 - Manual (Page 9)

HOW TO USE YOUR PRESSURE WASHER
if you have any problems operating your pressure washer,
please call the pressure washer helpline at 1-800-222-3136.
Pressure Washer Licallciii
Pressure Washer Clearance
A WARNING
M
Exhaust heat/gases can ignite combustibles,
structures or damage fuel tank causing a fire.
' Keep at least 5 ft. (152 cm) clearance on all sides of pressure
washer including overhead.
Place pressure washer outdoors in an area that will not
accumulate deadly exhaust gas. DO NOT place pressure
washer where exhaust gas (A) could accumulate and enter
inside or be drawn into a potentially occupied building.
Ensure exhaust gas is kept away from any windows, doors,
ventilation intakes, or other openings that can allow exhaust
gas to collect in a confined area. Prevailing winds and air
currents should be taken into consideration when positioning
pressure washer.
A WARNIHG
Running engine gives off carbon monoxide, an
odorless, colorless, poison gas.
Breathing carbon monoxide can cause headache,
fatigue, dizziness, vomiting, confusion, seizures,
nausea, fainting or death. _ _ _ _ _ _ _ _ _ _ _ _ _
Operate pressure washer ONLY outdoors.
Keep exhaust gas from entering a confined area through
windows, doors, ventilation intakes, or other openings.
DO NOT start or run engine indoors or in an enclosed area,
even if windows and doors are open.
To Start Your Pressure Washer
To start your engine-powered pressure washer for the first
time, foiiow these instructions step-by-step. This starting
information also applies whenever you start the engine after
you have let the pressure washer sit idle for at least a day.
1. Place pressure washer near an outside water source
capable of supplying water at a flow rate greater than
5.0 gallons per minute and no less than 20 PS! at pressure
washer end of garden hose.
2. Check that high pressure hose is tightly connected to
spray gun and pump. See Assembly ior illustrations.
3. Make sure unit is in a level position.
4. Connect garden hose to water inlet on pressure washer
pump.
NOTICE
DO NOT run the pump without the water supply connected
and turned on.
Damage to equipment resulting from failure to follow this
instruction will void warranty.
5. Turn ON the water, press red button on the gun and
squeeze the trigger to purge the pump system of air and
impurities.
6. Attach nozzle extension to spray gun. Tighten by hand.
7. Choose spray tip you want to use, puli back on collar of
nozzle extension, insert spray tip and release collar. Tug
on spray tip to make sure it is securely in place. See
How to Use Spray Tips.
8. Move fuel valve lever (B) to “On” position.