Maintenance – Craftsman 315.277011 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

MAINTENANCE

WARNING: When servicing use only identical

Craftsman replacement parts. Use of any other

parts may^ create a hazard or cause product

damage.

GENERAL

Only the parts shown on parts list, page thirteen, are
intended to be repaired or replaced by the customer.
All other parts represent an Important part of the
double insulation system and should be serviced oniy

by a qualified Sears service technician.

Avoid using solvents when cleaning plastic parts.

Most piastics are susceptibie to damage from various
t^Ms of commercial solvents and may be damaged
by their use. Use clean cloths to remove dirt, carbon
dust, etc.

WARNING: Do not at any time let brake fluids,

gasoiine, petroleum'based products, penetrating
oiis, etc. come in contact with plastic parts. They
contain chemicals that can damage, weaken, or
destroy plastic.

it has been found that eiectric toois are subject to
accelerated wear and possible premature failure when
they are used on fiberglass boats, sports cars,

watlboard. spackling compounds, or plaster. The

chips and grirKlings from these materials are highly
abrasive to electric tool parts such as bearings,
brushes, commutators, etc. Consequently, it is not
recommended that this tool be used for extended
work on any fiberglass material, wallboard, spackling
compounds, or plaster. During any use on these
materials it is extremely important that the tool is
cleaned frequently by blowing with an air Jet.

EXTENSION CORDS

The use of any extension cord will cause some loss of
power. To keep the loss to a minimum and to prevent

tool from overheating, use an extension cord that is

heavy enough to carry the current the tool will draw.

A wire gage size (A.W.G.) of at least 16 Is recom­

mended for an extension cord 100 feet or less in

length. When working outdoors, use an extension
cord that is suitable for outdoor use. "Rie cord's jacket
will be marked WA.

^ CAUTION: Keep extension cords away from the

sanding area and position the cord so that It will
not get caught on lumber, tools, etc., during

sanding.

iL WARNING: Check extension cords before each

use. If damaged replace Immediately. Never use

tool with a damaged cord since touching the

damaged area could cause electrical shock

resulting in serious injury.

Extension cords suitable for use with your sender ate
available at your nearest Sears Retail Store.

VL WARNING: Always wear safety goggles or

safety glasses with side shields during power tool
operation or when blowing dust. If operation is

dusty, also wear a dust mask.

LUBRICATION

All of the bearings in this tool are lubricated with a
sufficient amount of high grade lubricant for the life of

the unit under normal operating conditions. Therefore,
no further lubrication is required.

to

Advertising