Craftsman 486.248371 User Manual
Page 8
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
STEP 1: (SEE FIGURE 1)
• Assemble a shoulder bolt and a 3/8" nylock nut to the
holes shown on each side of the tractor frame.
STEP 3: (SEE FIGURE 3)
• Attach the frame brace between the front mount
plates using two 1/2" x 1-1/4" hex bolts, 1/2" x 1-1/2"
STEP 2: (SEE FIGURE 2)
• Place a front mount plate onto each shoulder bolt and
Install two quick release pins as shown.
STEP 4: (SEE FIGURE 4)
•
Measure from the center of the three holes Indicated
In figure 4 to select the hole that Is approximately 10"
above the ground In both front mount plates.
•
Install a shoulder bolt and 3/8" nylock nut In the
selected hole In each front mount plate.