Craftsman 580.763000 - Manual (Page 5)

ASSEMBLY
Remove the plastic cap from the high pressure out­
let. Feed the high pressure hose through the hose
guide and then connect the hose to the outlet Place assembled spray gun on holder.
HOSE GUIDE
* Connect nozzle extension to spray gun.
CHECKLIST
Before you operate your new high pressure washer,
to be sure you receive the best performance and sat­
isfaction from this quality product, please review the
following checklist: ,
• All assembly instructions have been completed.
• The high pressure hose connections to the spray
gun and to the pump are tight and secure.
While learning how to use your high pressure
washer, pay extra attention to the following important
items:
• Engine oil is at proper level
• Be sure gas tank is filled properly with clean,
fresh, unleaded gasoline.
» Become familiar with all controls - their location
and function. Operate those controls before start­
ing the engine.
CAUTION: Any attempt to crank or start
the engine before it has been properly
serviced with the recommended oil may
result In an engine failure. See Pages 8
and 9 for instructions on adding oil and
proper oil specifications.
ASSEMBLY PARTS PACKED IN MANUAL BAG SHOWN FULL SIZE
„ (4) Flat Washers
(4) #10 Self-drilling Screws '
(4) Hex Head Capscrews ~ M8 x 50mm
(4) Lock Washers (4) Hex Nuts