Tools required for assembly, Remove pressure washer from carton, Preparing the pressure washer for first use – Craftsman 919.670280 User Manual

Page 6

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

Tools Required for Assembly

Adjustable wrench

5 mm Allen wrench (supplied)

Remove Pressure Washer from Carton

Open carton from the top. Locate and remove from
box the handle, gun, wand,chemical/soap hose,

and parts bag.

Cut carton along dotted lines.

Remove all carton inserts.

Roll unit through opening in carton.

NOTE: The hose is located at the bottom of the
box.

Preparing the Pressure Washer for First Use

Note: Included with your pressure washer is a

video cassette tape on how to prepare your

unit for operation. It is recommended you view

this tape before performing the next steps.

1. Insert handle onto frame.

Insert knobs into the threaded slot in front of

the frame handle and tighten by turning in a
clockwise direction.

Slide bolts into the slot in the side of the frame
handle and tighten the nuts by turning in a
clockwise direction.

3.

2

.

Using an adjustable wrench, remove nut from bolt
that attaches board to frame. Remove wood plank

from the frame of the unit. Discard bolt and board.

Mount the rubber isolator to the frame. To mount

isolator place threaded end of bolt through the

washer.

Next with washer on bolt place threaded end

of bolt through the larger hole in bottom of
the rubber isolator.

Place threaded portion of bolt through the

same hole location the wood plank was
mounted to on the pressure washer.

Next place the tee nut over the threaded
portion of the bolt and use the 5 mm Allen

wrench provided to tighten isolator to the
frame.

TEE NITT

PRESSURE

WASHER

FRAME

BOLT

1-ISOLATOR

\

WASHER

4.

Connect wand extension to gun. To tighten, turn
knob in clockwise direction. Hand tighten.

5.

Remove tie wrap off of high pressure hose.
Unwind high pressure hose and attach the

threaded end to the gun. Tighten with adjustable
wrench.

6

.

Connect high pressure hose to outlet on
pressure washer and hand tighten firmly.

HIGH

- PRESSURE

HOSE

NOTE: Always keep hose away from engine muffler.

D20590 Rev 0 3/lS/OO

6-ENG

Advertising