Low oil shytdown, Gasoline – Craftsman 919.679370 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

gine damage due to lack or lubrication.

Use of SAE30 oil below 40°F (4°C) will result in hard start­
ing and possible engine damage due to inadequate lubri­

cation.

Low Oil Shytdown

Your Craftsman generator engine is equipped with Low
Oil Shutdown. Low Oil Shutdown is a safetydevice

designed to protect your engine from damage in the

event the oil level in the crankcase is low.

If while the engine is running, the oil gets low, it will

automatically shut itself down and will not restart until the

oil is added. If the oil is low before start-up, the genera­
tor will not start until oil is added.

NOTE: The Low Oil Shutdown mechanism is very sensi­

tive. You must fill the engine to the full mark on the

dipstick to inactivate this safety device.

Gasoline

Your generator engine is 4 cycle. Use unleaded fuel only.

Never mix oil with gasoline.

CAUTION; Never fill fuel tank completely. Fill tank to

1/2" below the bottom of the filler neck to provide

space for fuel expansion. Wipe any fuel spillage from

engine and equipment before starting engine.

WARNING: Never fill fuel tank indoors. Never fill fuel

tank when engine is running or hot. Do not smoke
when filling fuel tank.

Use clean, fresh, regular unleaded gasoline with a mini­

mum of 85 octane. Do not mix oil with gasoline. If unleaded

fuel is not available, leaded fuel may be used.

• Remove gas cap

• Add unleaded gasoline, slowly, to fuel tank.

• Do not overfill.

• On the engine there is a choke/run lever. Place lever

to the choke position.

CHOKE

LE¥ER"~-L^,

Throttle is factory set.

• Grasp the starter grip and pull slowly until resistance

is felt, then pull firmly to start engine.

• When engine starts, gradually move choke lever to

RUN position.

• If engine does not start after 5 pulls, place choke

back to run position.

• For hot engine starts make sure choke lever is in

the run position. Make sure fuel shut off valve is open.

12 - ENG

Advertising