Craftsman 113.225931 User Manual

Page 10

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

6. Fiind five; 3/Ö'' Pan Head iSelf-Trcàdtng screws from

'W/îamorigitHeddoi^

y :.. ■^

:^;y

7. Place Disc Dust Trap on your workbench and screw in

five Pan Head "Thread Gutting Screws," 3/8" long.
Screw them in all the way.

NOTE: The holes in theTrap are not threaded but the
screws are "Thre^ Cutting Screws" and will cut a
thread as they arc tightened.

DISC DUST TRAP

8. Find four Flat Head Machine Screws 1-%"lohg from

among the loose parts

9; Attach thé Disc Dust Trap with four flat head screws

10. There is a flat spot on the shaft near the end. Rotate

the shaft so that the flat spot is facing up.

FLAT HEAD SCREWS

5/32 INCH

11

. Place the disc on the shaft so that the set screw is

facing up. Position the disc SO that it is approx. 1/16

inch outward from the edge of the dust trap. :

12. Insert the long end of the 5/32" setscrew wrench

through the hole in the disc housing and into the

. setscrew in the disc. Make sure setscrew is aligned

/with "Flat" on shaft.

.

NOTE: After several hours of operation, check for

i; ■ y . looseness of setscrew and retighten. .

13: Make certain that the metal disc is free of oil and

grease then peel the backing from the 9" abrasive disc
and affix to the sanding disc,

; y

10

Advertising
This manual is related to the following products: