Craftsman 113.225931 - Manual (Page 18)

getting to know
on
f. Loosen the tabie positioning lock screw.. . ppsi-
tion the table approximately 1/16" ayyav ffP't’
the abrasive disc. ^ ^ ^ _
g. Tilt the table downward but don't tighten the lock
screw, and position it as close to the disc as pps-
sible. Using the head of a combination square,
check the angle of the table with the disc.
h. If the table is not 45° with the disc:
i. Raise the table and loosen the lock nut using a
7/16" wrench.
j. : Screw the stop screw in or out, using a 3/8'
wrench so that when the table touches it,: it is 45
with the disc.
■; '
k. Tighten the lock nut.
WARNING: To avoid trapping thé work or fingers
between the tabie and sanding surface; the table must
be repositioned on the rod to maintain a maximum
1/16 inch space between the table and sanding
surface.
ISC sonder
4 BACKSTOP LOCK locks the backstop in
place. It is locked using the 1/2" wrench.
BACKSTOP BACKSTOP
5. BELT TABLE LOCKING BOLTS ... lock the
belt table in position. / ........ ...............
To adjust to vertical position; :
a. Remove the backstop,
b. Loosen the two beit table locking bolts using the
1/2" wrench sullied with your machine.
c. Position belt table vertically and tighten the two
bolts.
6. ABRASIVE BELT TABLE STOP can be adj­
usted so that the abrasive belt table is level with
the floor w4ien in ahorirontai position.
a. Loosen the lock nut using a 3/4" wrench.
b, PI ace a level on the abrasive bel t table and using a
3/4-' wrench, screw the stop bolt in or but until
theTableis;ieyel.':\ ■ ■ ■ ' . - ■
18