Craftsman 113.225931 - Manual (Page 8)

Î^ObiËL 113iZ2S^
END STIFFENER HEX NUT
i ^LOCKWASHER
END
STIFFENER
i . AssertIbtS; the: tw^ the two (2)
Side Stiffeners using four (4) 1/4-20 Truss head
screwsi The EndiStiffeners are piaced on top of each
Side Stiffener as shbyyn. insert screws through the
; ,9/3Z: inch dianieter holes and finger tighten 1/4-20
2, Attach the four (4) legs to the side and End Stiffener
using 1/4-20 screws, lockwashers and nuts as shown.
3: Rerhove!the four (4) Truss head screws which were
assembled: in Paragraph No, One. Place the two (2)
; Support Channels as shown, in position, align holes in
supports with holes in the :Stiffeners, replace
ipckwashers and nuts. Tighten all nuts using 7/16"
//;wrenchv:::,: ' . .
4. Assemble the motor support tosteel legs with 1/4-20
screws and nuts. Motor support can bemounted to
5i Install leveling feet as shown. To level Leg Set, loosen
nut on: inside of leg and turn nut on outside to raise
Adjust all: four ievelers, if necessary,
and then tighten nuts on inside of leg.
: :: NOTE: These levels are not intended for height
adjustment. .....................: i:-, .■
SCREW
LEVELING
FEET
WHEN I nstalling OR moving the sander .
A void DANGEROUS environment . Use the sender in a
drVf indoor placé protected from rairi. Keep work area well
lighted. ■. .. ■ ' : ;■ ■■
■ ^ \ :: , V
Place the sander so neither the user nor bystanders are
forced to stand iii tine with the abrasive belt or disc:
To aWid injury from unexpected sander movement:
*: Put the sander oh a firm level surface where there is plenty
of room for handling and properly supporting thé
workpiece, .. . : , : : :
• Supportthe sander so it does not rock.
• Bolt the sander to the floor or work surface if it tends to slip,
walk, or slide during normal use. :
To avoid back injury, get help or use recommended casters
when you need to move the sander. Always get help if you
need to lift the sander.
NEVER STAND ON TOOL. Serious injury could occur if the
tool tips or you accidentally hit the cutting toot. Do not store
anything above or near the tool where anyone might stand on
the tool to reach them.
MOUNTfNG BELT AND DISC SANDER ON
CRAFTSMAN STEEL LEG SET.
catalog NO. 9-22236
NOTE; Forillusfrativepui'posesj the Belt and Disc Sander is
shown mounted on the Craftsman Cataiog No. 9^22236
Steel Leg Set. This Leg Set is included with Model No.
113.22593r. :■ ;: v " ■ ■■