Craftsman 320.28190 - Manual (Page 11)

INSPECT the tool cords periodically and if damaged have them repaired
at your nearest Sears Service Center. BE AWARE of the cord location.
ALWAYS check the tool for damaged parts. Before further use of the tool, a
guard or other part that is damaged should be carefully checked to determine
if it will operate properly and perform its intended function. Check for mis­
alignment or binding of moving parts, breakage of parts, and any other condi­
tion that may affect the tool’s operation. A guard or other part that is damaged
should be properly repaired or replaced at a Sears Service Center.
INSPECT and remove all nails from lumber before routing.
SAVE THESE INSTRUCTIONS. Refer to them freguently and use them
to instruct others who may use this tool. If someone borrows this tool,
make sum they have these instructions also.
WARNING: Your router should NEVER be connected to the power
source when you are assembling parts, making adjustments, installing or
removing collets / nuts, cutting bits, cleaning or when it is not in use. Dis­
connecting the router will prevent accidental starting, which could cause
serious personal Injury.
1. Ca-efully lift the Router Motor and Fixed Base, with the 1/2 in. collet/nut already
installed, out of the color box and place it on a stable, flat surface.
2. Open the parts bag to locate the following:
• Edge Guide
® 1/4"in. Collet/Nut
» Collet/Nut wrench
® Power cord
® Sawdust extraction adapter
® Depth-adjustment wrench
3. Inspect the items carefully to make sure that no breakage or damage has
occurred during shipping. If any of the items mentioned are missing, (refer to
“PARTS LIST’ illustration on page 12), return the router to your nearest Sears
store or Craftsman outlet to have the router replaced.
WARNING: If any parts are broken or missing, DO NOT attempt to plug
in the power cord or operate router until the broken or missing parts are
replaced. Failure to do so could result In possible serious injury.
28190 Manual Revised 070409 Page 11