Craftsman 320.28190 User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
10. Durable Non-Marring Sub-Base glides smoothly over work piece. Sub-base
has cutter-bit opening of 1-1/4 inch. Do Not Use a bit with a cutter diameter
larger than 1-1/4 in., as it will not pass through the sub-base opening!
11. Base constructed of magnesium to provide light weight, durability and stability.
12. Router Motor housing constructed of High Density Nylon and Precision
Milled Cast Aluminum for strength and exact fit into base.
13. High-impact resistant Router Motor Top Cap and Handles on Base helps
protect tool from damage.
14. Heavy-duty Edge Guide for most routing applications such as decorative
edging, grooving, dadoing, slotting and straight edge planing /rimming.
15. Conveniently located On/Off Toggle Switch, side mounted for added vis
ibility, easy access.
16. Sawdust Extraction Hood allows base to hook up to 1-1/4 inch vacuum
hose attachment, sold separately.
17. “LIVE TOOL INDICATOR” Light is green when saw is plugged into a power
source. Light is located on router motor top cap next to power cord inlet.
18. Replaceable Brushes (sold separately) for dependable service.
19. Includes carry bag for easy carrying and storage.
20. Integrated Depth-adjustment Wrench hole of the base for adjusting the
depth of cut from above the table with depth-adjustment wrench.
NOTE: This tool is shipped completely assembled. To install or remove bits
or add accessories such as sawdust ejection hoods for hook-up to vacu
ums, see the following instructions.
SELECTING THE CUTTING BIT
This router comes with 1/4-in. and 1/2-in. collets/nuts that accept 1/4 and 1/2
inch diameter shanked cutting bits.
WARNING: Do not use router cutting bits that have a cutting bit diame
ter larger than 1-1/4 Inches as they will not fit through the sub-base opening,
and will cause damage to the sub-base, the router motor, and could cause
serious personal injury to the operator.
NOTE: The sub-base installed on this router has an opening of 1-1/4 inches.
To use cutting bits with a larger diameter, use a sub-base with a larger
opening, sold separately at Seam stores or other Craftsman outlets.
A
WARNING: ALWAYS turn router motor off and unplug router before mak
ing any adjustments or installing accessories. Failure to unplug the router
could result in accidental starting which can cause serious personal injury.
28190 Manuai_Revised_07O4O9
Page 15