Craftsman 706.596690 User Manual

Page 31

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

DRAWER AND WORK SURFACE

INSTALLATION AND REMOVAL
Note: For pull out work surface without

task light, follow drawer removal

instructions.

DRAWER

• Empty the drawer.
• Fuliy extend the drawer.

Release

Lever Style

- Lift or

ower (depending on the

slide) the release lever

on both sides, (this

allows the slides to ride

over the stops.) Pull out
to remove.

Tab Style

- Depress the

release tabs on both
sides, (this allows the
slides to ride over the
stops.) Pull out to
remove.

To reinstall, carefully align the slides

and push the drawer into the unit until
the drawer stops.

PULL OUT WORK SURFACE WITH

TASK LIGHT

Removal

• Disconnect the power from the unit.
• Remove enough drawers to gain

access to connections in the back of

the roll-away behind the work surface.

Unplug work surface cord from back of

roll-away.

Remove and save back retaining clip.
Disconnect chain inside back of roll-

away. (Move chain toward large round
part of slot. Pull out to remove.)

Remove the work surface. (See

drawer removal instructions.)

Retaining

To reinstall, carefully align the slides

and push the work surface into the unit
until the work surface stops.

Depress release tabs in back corners

of the extendable work surface.
Push the work surface into the unit to

the fully retracted position.

Extend work surface far enough to

gain access to connections in back.
Connect chain inside back of roil
away. (Insert chain into the large
round part of the slot. Slide chain to
small end of slot.)

Insert retaining clip to hold chain in

place.
Plug work surface cord into back of
roll-away.

Reconnect power to the unit. (See:

Connecting power.)
Check work surface and task lighting

for proper operation.

Reinstall drawers.

Advertising
This manual is related to the following products: