C for liquid wax – Craftsman 646.10620 User Manual
Page 4
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
C FOR LIQUID WAX
Apply three swirls of liquid wax on the wax
applicator bonnet. DO NOT APPLY WAX
DIRECTLY TO CAR. This first application
should do about 1/4 of the car. The bonnet
will not absorb as much when reloading.
ALWAYS START AND STOP THE
POLISHER ON OR AGAINST THE
SURFACE.
Place the extension cord over your
shoulder and do flat surfaces first—hood,
trunk and roof. Cover areas quickly with
broad, sweeping strokes in a criss-cross
pattern.
DO NOT press down on the polisher.
The machine’s action, not pressure,
does the best job.
After flat surfaces are covered with wax,
do sides of the car. Hold the polisher as
shown. Let the cord hang free. It is not
necessary to use a criss-cross motion on
doors and fenders.
Remove the wax applicator bonnet and
use it to hand-polish all hard-to-reach
surfaces: under the bumpers, around the
door handles, etc.
LEF
nUKT
Throw away the wax applicator bonnet
and put a clean terrycloth bonnet on the
polisher.
H
Polish the wax in the same order it was
applied. Use long, sweeping strokes in a
criss-cross pattern. Do not press hard. Let
the polisher do the work.