With other cameras, On position, With the nikon fa, fe2, and fg – Nikon SB 20 User Manual
Page 48: Off position
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
With other cameras:
Though the ON position is normally recommended for
turning on the flash unit, STBY can also be used.
With other Nikon cameras, even if the camera’s expo
sure meter stays on, the SB-20 automatically turns off
when not used for one or two minutes. To turn on
again, set power switch to ON or OFF position, then
reset to STBY. For convenience, you may also push
the open-flash button to turn on the SB-20.
ON Position
With cameras other than the Nikon F-501/N2020,
F-401/N4004, F-301/N2000, FA, FE2, and FG:
This position is normally used to turn on the SB-20.
With the Nikon FA, FE2, and FG:
To turn on the SB-20 when using mechanical shutter
settings (M250, MOO or B), set power switch to ON.
OFF Position
When not using the flash unit, always set the power
switch to OFF position.
33