Preparation for use, Installing the batteries, Checking battery power – Nikon fe User Manual
Page 7
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARATION FOR USE
Installing the Batteries
The Nikon FE’s built-in exposure meter and the elec
tronic shutter control circuits are powered by two
button-cell type 1.55V silver-oxide batteries or one 3V
lithium battery. These are mounted in the battery clip,
which forms a single unit with the battery chamber’s
coin-slotted lid, in the camera’s baseplate. To install the
battery or batteries, first unscrew the lid by turning it
counterclockwise, with a coin or something similar, until
it can be freely removed by hand. Then, seat the battery,
or the two batteries one on top of the other, in the bat
tery clip, making sure that the respective plus (+) and
minus (—) signs correspond with similar marks provided
in the clip. After seating the batteries correctly, replace
the lid, and secure the connection by turning it clock
wise with the coin as far as it will go. It is advisable to
remove the batteries, when the camera is not to be used
for a long period, to prevent battery leakage within the
camera; for additional information, refer to “Tips on
Camera Care” on page 39.
2
)
Checking Battery Power
To check battery power, simply turn the power check
lever downward and watch the power check lamp. If the
lamp fails to glow, check the battery seating and make
any necessary adjustments. Should the lamp still fail to
ight up. Install new batteries.
Caution:
1) When the camera is not in use, make sure that the film-ad
vance lever is positioned flush with the camera body. As the
lever doubles as the meter on-off switch, leaving it in the
stand-off position will result in the camera's battery being
completely drained In just a few days.
When the camera is attached to the MD-12 motor drive, make
sure the motor drive is switched off when It is not in use to
prevent drain of both the camera and the motor drive's
batteries.
3) When the batteries are dead or there are none installed in the
camera, the only two settings which can be used are “M90"
and “B.” If you trip the shutter with the camera set to any
other speed, the shutter won't open or the reflex mirror may
remain In the “up" position. If the mirror locks
up, simply turn the shutter speed dial to “M90"
and the mirror will return to Its normal viewing
position. Then you can
install new batteries.
To avoid wasting
a frame, stroke
the winding lever
while holding in
the multiple-
exposure lever.