Attaching grip gr-e2 – Canon EOS 1 V HS User Manual

Page 120

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

For EOS-1 VHS Users

Attaching Grip GR-E2

You can replace the Power Drive Booster PB-E2 with the normal Grip GR-

E2 (sold separately) found on the EOS-1 V.

The GR-E2 uses one lithium 2CR5 battery.

Install a battery in the Grip GR-E2.
(-^p.19)

• As shown in the diagram, insert the

battery with the contacts toward the
bottom right. Then close the cover.

Detach the Power Drive Booster
PB-E2.

• Turn the Power Drive Booster PB-

E2’s attachment knob as shown by

the arrow to loosen it. Then slide
down the Booster.

• On the bottom of the EOS-1 V, attach

the cover (provided with the GR-E2)

on the film advance coupler, (-^p.8)

Attach the Grip GR-E2.

• Attach the Grip to the camera and

tighten the Grip’s attachment screw.

• Attach the contact cover (provided

with the GR-E2) to the Power Drive

Booster PB-E2 to protect the

electrical contacts.

o

Cautions when using the Power Drive Booster PB-E2 with the EOS-1 and EOS-1 N

• Do not use size-AA lithium FR6 batteries or the Nickel-Hydride Pack NP-E2

with the EOS-1. Doing so may damage the EOS-1 ’s electronic circuitry due to

the high battery voltage.

• Do not use the Nickel-Hydride Pack NP-E2 with the EOS-1N. if the battery

voltage gets really low, battery pack performance may deteriorate markedly.

118

Advertising
This manual is related to the following products: