Casablanca Nouvelle - Manual (Page 5)

4
ADAPTOR PLATE INSTALLATION
JOIST
Step 2. Route the outlet box wires through the 1 / 2
″
diam-
eter outer hole of the canopy adaptor plate. Attach the
crossbar and canopy adaptor plate to outlet box with screws
provided.
Step 3. With the large washer attached, pass the lag screw
through the center hole of canopy adaptor plate and screw
into guide hole. Tighten until outlet box is firmly mounted
to beam. This box must be firmly secured to the ceiling. We
recommend that the ceiling fixture outlet box be of suffi-
cient capacity enabling it to support the weight of fan and
light fixture under any conditions.
LAG
SCREW
LAG SCREW INSTALLATION
1 / 2
″
DIAMETER
OUTER HOLE
CEILING
WIRING
CROSSBAR
MOUNTING
BRACKET
FLAT
WASHER
GREEN
GROUND
WIRE
CEILING FAN
APPROVED
WIRING BOX
RIDGE
SIDE
DOWN
APPROVED
OUTLET BOX
HARDWARE
Note: After removing the old fixture, check the outlet box
to insure that it is supported by a joist or beam across its
upper surface. If not, a 2" x 4" stud must be installed.
Proceed with installation as follows:
Step 1. Remove the knockout plug in the center of the outlet
box or drill a
1 / 2
″
hole for the lag screw to pass through. Then
drill a 1 / 4
″
guide hole into the joist or beam to a depth of 3
″
.
LARGE
WASHER
N
OUVELLE
™
WARNING!
SUPPORT DIRECTLY TO
BUILDING STRUCTURE.
CAUTION: To reduce the risk of personal injury,
use only the mounting hardware provided with
the approved outlet box to install the crossbar
mounting bracket.