Élégtrigal requirements for elegtrig dryers – LG ELECTRIC AND GAS DRYER D 5988W User Manual
Page 16
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
ÉLÉGTRIGAL REQUIREMENTS FOR ELEGTRIG DRYERS
Option 1: 3-Wlre Connection with
a Power Suppiy Cord
If your local codes or ordinances permit the
connection of a frame-grounding conductor to the
neutral wire, use these instructions. If your local
codes or ordinances do not allow the connection of
a frame-grounding conductor to the neutral wire,
use the instructions under Section 3; Optional
3-wire connection.
a.
b.
c.
d.
в.
f.
g-
3-wire receptacle (NEMA type 10-30R)
3-wire plug
Neutral prong
Spade terminals with up turned ends
3/4 in. (1.9 cm) UL approved strain relief
Ring terminals
Neutral (white or center wire)
1. Loosen or remove center terminal block screw.
2. Connect neutral wire (white or center wire) of
power supply cord to the center, silver colored
terminal screw of the terminal block. Tighten
screw.
a.
External ground connector
b.
Neutral grounding wire (white)
c.
Center silver-colored terminal block screw
d.
Neutral wire (white or center wire)
e.
3/4 in. (1.9 cm) UL-Hsted strain relief
3. Connect the other wires to outer terminal block
screws. Tighten screws.
4. Tighten strain relief screws.
5. Insert tab of terminal block cover into slot of
dryer rear panel. Secure cover with hold-down
screw.
1 6