Astak R4020A - Quick Start Guide - Manual

[email protected]
Easy Travel Router Setup
 Connect the mini router WAN port to an internet
source via network cable.
 Plug the micro-USB cable into the router with a
USB powered source, e.g., computer USB port or
wall charger.
 (a) Wired Connection: Connect computer to the
Router LAN port with network cable.
(b) Wireless connection:
Network Name/SSID: MiniRouter
Network Password/Key: 123456789
Note: If you only use the device as a travel router,
you do NOT need to proceed to Step1 and further.
0 Advanced Configuration

(Important) Connect PC to the mini router LAN
port with network cable.
 Open up a browser, e.g. IE, and go to web
address: 192.168.100.1
 A login is required:
Username: admin
Password: admin
Note: Maintain wired connection from PC to the
router until you finish the entire setup process for
advanced configuration.
Reset: If you have any difficulty during the setup,
press and hold the Reset button for more than 5
seconds to restore factory settings.
1
Advanced Setup— AP Router Mode

 Complete Step 1.
 In the configuration page of the Operation Mode,
select “Gateway mode” and then “Apply Change”
 Go to the Setup Wizard, and follow the
instructions to finish the setup.
 The Router needs to reboot to activate your
settings
 Set the password in the Wireless encryptions to
protect your wireless connection.
Advanced Setup—Repeater Mode
 Complete Step 1.
 In Operation Mode, select “Bridge” and then “Apply Change”.
 Go to "Wireless", "Basic Settings", select "Client" on "Wireless
Mode", select "Enable Universal Repeater Mode", and create
a name on "SSID of Extended Interface", apply changes and
click "Reboot Later".
 In "Security", select the newly created SSID, choose
"WPA-Mixed" on "Encryption", and type a password on
"Pre-Shared Key". Apply changes and click "Reboot Later".
 Go to "Site Survey", choose home network, click "Next", type
in the wifi password on "Pre-Shared Key", and hit "Connect".
 Wait about 30 seconds and then reboot the mini router.
 You repeater network with new SSID is ready to use.
Advanced Setup—Client Mode
 Complete Step 1.
 In Operation Mode, select “Bridge” and then “Apply Change”.
 Go to "Wireless", "Basic Settings", select "Client" on "Wireless
Mode", apply changes and click "Reboot Later".
 In "Site Survey", choose your home network, click "Next", type
in the wifi password on "Pre-Shared Key" and "Connect".
 Wait about 30 seconds and then reboot the mini router.
 Connect your device to one of mini router Ethernet ports with
a network cable, and now your wired-only device can also be
used wirelessly by client mode.
Note: When the router is in Bridge mode, both WAN and LAN ports
will become LAN ports.
A R
C
Advanced Setup—WPS Function

This Router supports WPS. Before you use this
function, please enable WPS under Wireless
settings in the configuration website, and also set
the key for it.
 How to use WPS：
 Push the button on the bottom of the router.
 The WPS LED on the router will start to
blink.
 Push the WPS button on the device, it will
connect automatically.
W