Attwood Sportline Glove Boxes - Manual

TOOLS REQUIRED FOR MOUNTING:
1. Drill and suitable bits
2. Six (6) #8 screws
3. Saber saw with appropriate saw blades
4. Prick-punch
5. Soft lead pencil
Standard and Sportline
Glove Boxes
2638, 2715, 2716
Installation Instructions
SAVE THESE INSTRUCTIONS
Form Number 69144 Rev. B
03-11
FEATURES:
Attwood glove boxes are specially designed for those who
enjoy a more sport-styled look. The Sportline glove box is a
matched companion to the Sportline steering wheel.
These glove boxes are made of rugged black plastic. The door
incorporates a marine locking latch. Located inside the door
are two drink holders that will help keep your beverages in
place when the door is open.
INSTALLATION INSTRUCTIONS:
1. Cut out glove box template.
2. With a soft lead pencil, blacken behind sheet compartment
hole cut line and the four corner saber saw cut drill holes.
3. Tape template in your desired location. Leave room for over-
all glove box dimensions as indicated on your template.
4. Mark the center of the four corner holes with prick-punch.
5. Drill 3/8" diameter starting holes and cut away on inside line.
6. Trace over compartment hole cut line connecting the four
3/8" diameter holes in each corner as shown and remove
template. Carefully saber saw along the cut line starting the
saw blade at one of the corner holes.
7. Install glove box and hold in position while marking the six
screw holes as indicated on illustration inside template.
Remove glove box.
8. Drill the six mounting screw holes where prick-punch marks
are located.
a. If wood or self-tapping screws are used, drill 1/8" diameter
hole into dash.
b. If screws with nuts are used, drill 3/16" diameter holes
through dash.
9. Install glove box into mounting hole and secure with #8
screws.
CAUTION:
Do not use acetone or other solvents on box or door.
© 2003 Attwood Corporation
1016 N. Monroe Street, Lowell, MI 49331-0260
www.attwoodmarine.com
(CUT & DETACH FROM INSTRUCTIONS)
TOP OF GLOVE BOX DOOR
TOP OF MOUNTING FLANGE
DRINK HOLDERS
1/2" FINGER ROOM
CUT LINE
CENTER LINE
MOUNTING HOLES
6 LOCATIONS
FOR LIGHT
IF REQUIRED
TOP
3/8" DIAMETER HOLE FOR
SABRE SAW (ALL FOUR CORNERS)
GLOVE BOX
INSTALLATION TEMPLATE
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
BOTTOM