Autotech 10.109.420 260 Sport Hydraulic Lifter Camshaft, Mk1, Mk2, Mk3 8V & Corrado G60 - Manual

Installation Instructions
Part Number: 10.109.420
Description: AUTOTECH Sport 260 Hydraulic Camshaft
Note:
If the job seems to be beyond your abilities, we recommend that you refer this installation to a qualified mechanic. Please
read through the instructions before starting your installation to ensure that you have the tools and understanding of the
task. A Bentley repair manual for the model and year vehicle you are installing the camshaft in is also highly recommended
for this task.
Procedure:
1. Remove the upper drive belt cover by pulling back the clips at the top of the cover and lifting the cover up and out. Remove
the idle stabilizer valve and hose (if equipped) to facilitate valve cover/camshaft removal and installation. Remove the two
braces running from the valve cover to the intake manifold. Disconnect the crankcase ventilation hose from the emission
control valve (fig 1, disregard arrows.) Disconnect the electrical connector at the fuel after-run control valve. Remove the
eight nuts holding the valve cover down. Lift off valve cover while taking care not to damage the rubber valve cover gasket.
2.Move camshaft sprocket to cylinder number one TDC mark by turning the crankshaft clockwise with a 19mm socket until
the dot on the camshaft pulley lines up with the upper edge of the camshaft drive belt inner cover (fig 3.) Check TDC by
removing the distributor cap and making sure that the rotor is lined up with the notch on the distributor (fig 2.) The flywheel
should also be at TDC (fig 4.) If these marks do not line up, you will need to continue to rotate the crankshaft until they do.
3.Loosen belt tensioner with a 15mm open end wrench and slide off the camshaft drive belt, while keeping the belt tension on
the lower sprockets so that they don’t move or slip. If they do, you will probably have to re-align them in a time consuming
procedure described separately. By tying the belt via a bungee or other cord to the hood or laying the belt towards the rear
using a weight (wrench etc…) to keep the belt tension, you can install the cam without having to re-align all of the lower
sprockets.
4.Remove bearing caps one and three, in that order. Take note of which end of each cap is pointing towards you. Caution: The
bearing caps are offset, and will break if re-installed backwards and tightened down. Next, remove the nuts from bearing caps
two and five a little at a time and crosswise so that the spring tension is evenly relieved. Lift cam with attached sprocket out
of the head.
5.Loosen the camshaft sprocket bolt 1/2 to ¾ turn and tap the sprocket loose using a soft faced hammer. Remove the bolt
completely and remove the sprocket, woodruff key, and cam seal. Lightly coat the cam seal with oil and place on the new
camshaft. Install the woodruff key and sprocket onto the new camshaft and for A1, A2, A3 and Corrado G60 motors, torque
the cam sprocket mounting bolt to 59 ft/lb. For A4 2.0 8v motors, tighten the cam sprocket mounting bolt to 74 ft/lb
6.Apply oil to the bearing surfaces, and a small amount of assembly lube to the lobes of the new camshaft. Lay the camshaft in
the head with the lobes for the number one cylinder facing up. Install bearing caps two and five, tightening down gradually
and crosswise until the camshaft is pushed completely in to the bearing saddles. Install the remaining bearing caps and
torque all nuts to 15 ft/lb.
7.Check to see if the dot on the inside of the cam sprocket lines up with the upper edge of the camshaft drive belt inner cover
(fig. 1.) If not, rotate cam slightly until it does.
8. Slide camshaft belt over cam sprocket, taking care not to disturb the alignment of the camshaft sprocket.