Salter Brecknell PB500 - Manual (Page 3)

3
Counting
1. Be sure the balance is on and the display shows 0.0. Place the sample
size you want (25, 50, 75 or 100 items) on the balance.
2. Press and hold COUNT until …
100 is displayed. This is the default sample size.
3a. Press COUNT to accept this sample size …
OR
3b. Press MODE to change the sample size and press COUNT when the
sample size you want is displayed …
The display will show 100pcs (or 25pcs, 50pcs, 75pcs).
4. Replace items on the scale to continue counting.
5. Press MODE to return to normal mode.
Calibration
1. Be sure the balance is on and the display shows 0.0.
2. Press and hold MODE until …
CAL is displayed.
3. Press MODE …
CAL blinks then shows 500g blinking.
4. Place 500g of weight on the balance …
After few seconds, PASS is briefly displayed, then 500g.
5. The calibration is complete and you are ready to weigh.