Code 3 PSE LED F12 12 Output Flashers User Manual

12 output led flasher multi-pattern, Pseledf12

Advertising
background image

1

12 OUTPUT LED FLASHER MULTI-PATTERN

PSELEDF12

ELECTRICAL SPECIFICATION

Input Voltage Range

+10 Vdc to +16 Vdc

Output Drive Current

3 Amps per Output

Operating Temperature

-40 C to +85 C

Flash Patterns

Quint, Quad, Triple, Double,
180 fpm Alternating Single,
120 fpm Alternating Single,
120 fpm Simultaneous Single,
90 fpm Alternating Single,
90 fpm Simultaneous Single,
75 fpm Alternating Single,
75 fpm Simultaneous Single,
Cycle Flash
Sweep (Lightbar version only)
Fast Random

Output Drive Method

Low-side switched

Pattern Control Method

1 Serial Programming
input, 3 Progressive Operation
mode inputs, Front & Rear
Cutoff inputs

Standby Current

<10mA @ 12.8 Vdc

Reverse Polarity Protection

Yes

Short Circuit Protection

Yes

Thermal Protection

Yes

MECHANICAL SPECIFICATIONS

Weather resistance

Potted to protect circuitry, but not
waterproof

Dimensions

6.0" x 3.6" x .75"

WARNING

This device is intended for use with LED Lights ONLY!! Use of this product on an Incandescent, Halogen or
any light source other than LED's may damage the unit and void the warranty.

The use of this or any warning device does not insure that all drivers can or will observe or react to an
emergency warning signal. Never take the right-of-way for granted. It is your responsibility to be sure you
can proceed safely before entering an intersection, driving against traffic, responding at a high rate of
speed, or walking on or around traffic lanes.
The effectiveness of this warning device is highly dependent upon correct mounting and wiring. Read and
follow the manufacturer's instructions before installing or using this device. The vehicle operator should
insure daily that all features of the device operate correctly. In use, the vehicle operator should insure the
projection of the warning signal is not blocked by vehicle components(i.e., open trunks or compartment
doors), people, vehicles, or other obstructions. This equipment is intended for use by authorized personnel
only. It is the user's responsibility to understand and obey all laws reguarding emergency warning devices.
The user should check all applicable city, state and federal laws and regulations.
Code 3, Inc., assumes no liability for any loss resulting from the use of this warning device. Proper
installation is vital to the performance of this warning device and the safe operation of the emergency
vehicle. It is important to recognize that the operator of the emergency vehicle is under psychological and
physiological stress caused by the emergenct situation. The warning device should be installed in such a
manner as to A) Not reduce the output performance of the system, B) Place the controls within convenient
reach of the operator so that he can operate the system without losing eye contact with the roadway.
Emergency warning devices often require high electrical voltages and/or currents. Properly protect and use
caution around live electrical connections. Grounding or shorting of electrical connections can cause high
current arcing, which can cause personal injury and/or severe vehicle damage, including fire.
PROPER INSTALLATION COMBINED WITH OPERATOR TRAINING IN THE PROPER USE OF EMERGENCY
WARNING DEVICES IS ESSENTIAL TO INSURE THE SAFETY OF EMERGENCY PERSONNEL AND THE PUBLIC.

Figure1

WARNING

This Flasher is NOT waterproof!! This unit must
be installed in a location protected from the
environment.

The device is designed to flash Code 3, Inc. 12 volt
LED-EX Lights up to 3 amps load per output. DO NOT
connect more than a 3 amp load(two single LED-EX
equivalent) to the output. Doing so will shut the unit
down to prevent damage to the Flasher.

Advertising