Chauvet COLORMIST MIST-CON - Manual (Page 7)

COLORmist
™
System User Manual 7 2005-10-10/18:36
M System Setup M Single Action
Main Menu
1 DMX Ch (0 – 508)
2 Set Address (N / A)
3 Lamp Amount (0 – 250)
For a detailed listing of Single
Action programs proceed to the
next page.
O
PERATING
I
NSTRUCTIONS
Control Panel
On the control panel you can set the controller for single action mode where preset programs are run
either statically, automatically or by sound-activation or assign a starting DMX channel address.
Menu Diagram
System Setup
You will need to let the controller be aware of the number of par cans and/or panels connected in
series. This is essential in order for the chase and flow programs to perform correctly through out the
entire stretch of fixtures.
I n i t i a l S e t u p
1. Press the MODE button until the display shows
“
M System Setup
”
.
2. Press the SETUP button then the UP button once. It will show
“
3 Lamp Amount
”
.
3. Press the SETUP button to enter the function. A number will now appear to the right of the text as
shown here in an example.
“
3 Lamp Amount 34
”
.
4. Use the UP and DOWN buttons to locate a number between 0 and 250. This represents the
number of fixtures connected.
5. Press the MODE button to set this function.
R e - i n i t i a l i z a t i o n
Whenever a fixture is removed, replaced or exchanged please follow the following instructions.
1. Press the MODE button until the display shows
“
M System Setup
”
.
2. Press the SETUP button then the UP button twice. It will show
“
2 Set Address
”
.
3. Press the SETUP button to re-initialize.
4. Proceed to prior instruction
“
Initial Setup
”
and re-do.
MENU SETUP UP DOWN
[MENU] Returns to Main menu or step backward through functions
[SET UP] Enters menu selection
[UP] Steps backward through menu selection
[DOWN] Steps forward through menu selection