Habey FW-1044 - Manual (Page 3)

www.habeyusa.com www.habeyusa.com
Align notch in memory circuit with
corresponding guide on the memory slot.
Insert the memory circut at a 45° angle and
press the circuit flat and secure it to the
memory slot with an audible click on each
side of the memory slot.
Step 4 - Memory
Step 7 - Rack Mounting
Locate the included rack mount brackets
(ears). Mount the ears to the front side of the
enclosure by securing the ears to the side of
the enclosure with the included screws.
Your system is now ready. Connect the power cable to a power source and
press the power button on the front of the system.
Step 8 - Hardware Installation Complete
Step 6 - Themal Pad
Step 5 - VGA
If a VGA connector is needed, punch out the
VGA port on the rear of the chassis. Connect
the VGA head to the chassis and attach the
connector to the board pin headers.
Apply the themal pad on to the heat sink.