Chrysler uconnect 5.0 for Chrysler - Manual (Page 23)

AUX Mode
AUX Mode is entered by inserting a AUX device using a
stereo cable with a 3.5 mm audio jack into the AUX port,
or by pushing the MEDIA button located on the face-
plate. Once in Media Mode, press the “Source” button on
the touchscreen and select “AUX.”
Inserting Auxiliary Device
Gently insert the Auxiliary device cable into the AUX
Port. If you insert a Auxiliary device with the ignition
ON, the unit will switch to AUX mode and begin to play
when you insert the device cable.
Controlling The Auxiliary Device
The control of the Auxiliary device (e.g., selecting play-
lists, play, fast forward, etc.) cannot be provided by the
radio; use the device controls instead. Adjust the volume
with the VOLUME/MUTE rotary knob, or with the
volume of the attached device.
The vehicle radio unit is acting as the amplifier for audio
output from the Auxiliary device. Therefore if the volume
control on the Auxiliary device is set too low, there will be
insufficient audio signal for the radio unit to play the
music on the device.
22 MEDIA MODE