Kontron CG2100 Carrier Grade Server User Manual
Kontron cg2100 carrier grade server
Advertising
Table of contents
Document Outline
- 1 Introduction
- 2 Features
- 2.1 Server Components
- 2.2 CG2100 Server Front Panel
- 2.3 CG2100 Server Back Panel
- 2.4 Front Panel Board
- 2.5 LED/Switch Board
- 2.6 Hard Disk Drives
- 2.7 SD Flash Module
- 2.8 Server Board (Baseboard)
- 2.9 Riser Card Assembly
- 2.10 Ethernet NIC Ports
- 2.11 Remote Management Module 3
- 2.12 Power Supply Subsystem
- 2.13 System Cooling
- 2.14 Processors and Memory DIMMs
- 3 Standard Component Installations and Upgrades
- 3.1 Before You Begin
- 3.2 General Installation Procedures
- 3.3 Internal System Components Configuration and Installation Procedures
- 4 Optional Component Installation Procedures
- 4.1 Before You Begin
- 4.2 Installing or Replacing Hard Disk Drives
- 4.3 Installing a SAS/SATA Control Module
- 4.4 Installing a Hardware RAID Module
- 4.5 Installing a RAID Intelligent Battery Backup Unit (IBBU)
- 4.6 Adding a Second Power Supply Module
- 4.7 Installing a PCI Riser Card
- 4.8 Installing PCI Add-in Cards
- 4.9 Installing a Personality Module
- 4.10 Installing a Remote Management Module
- 4.11 Installing an SD Flash Module
- 4.12 Installing a USB Solid-State Drive
- 4.13 Installing the Server into a Rack
- 5 Server Component Replacements
- 5.1 Before You Begin
- 5.2 Replacing Fans
- 5.3 Replacing the Bridge Board
- 5.4 Replacing the Front Panel Board
- 5.5 Replacing the LED/Switch Board
- 5.6 Replacing the Telco Alarms Module (TAM)
- 5.7 Replacing the Power Distribution Board
- 5.8 Replacing the T5520UR Server Board
- 5.9 Replacing the SAS/SATA Backplane Board
- 6 Server Utilities
- 7 Troubleshooting
- 7.1 Resetting the System
- 7.2 Problems Following Initial System Installation
- 7.3 Hardware Diagnostic Testing
- 7.4 Specific Problems and Corrective Actions
- Power Light does not Light
- No Characters Appear on Screen
- Characters are Distorted or Incorrect
- System Cooling Fans do not Rotate Properly
- Cannot Connect to a Server
- Diagnostics Pass but the Connection Fails
- The Controller Stopped Working When an Add-in Adapter was Installed
- The Add-in Adapter Stopped Working without Apparent Cause
- System Boots When Installing a PCI Card
- Problems with Newly Installed Application Software
- Problems with Application Software that Ran Correctly Earlier
- Devices are not Recognized under Device Manager (Windows*OS)
- Hard Drive(s) are not Recognized
- 7.5 LED Information
- 8 Warranty
- 9 Appendix A: Safety Information
- 10 Appendix B: Regulatory and Certification Information
- 11 Appendix C: Getting Help