Cisco OL-6109-01 - Manual (Page 22)

Chapter 4 Zone Configuration
Zone Detection
4-22
Cisco Traffic Anomaly Detector User Guide
OL-6109-01
The sample screen indicates that zone traffic is mirrored (or split), the Detector
receives the zone’s traffic and the traffic shows normal flow fluctuations. Zone
detection is functioning properly.
Ending the Zone Detection
The user may wish to end the zone detection.
To end a zone’s protection, from the Global command group level type the
following:
admin@DETECTOR# no detect <zone-name>
Or alternatively:
From the Zone command group level type the following:
admin@DETECTOR-conf-zone-<zone-name># no detect
Where zone-name specifies a zone name.
Note that the Detector enables the use of an asterisk (*) as a wildcard denoting
either of the following options:
• All of the Detector’s zones. Issuing no detect * means ending detection for
all of the Detector’s zones.
• A wildcard denoting zone names (i.e. OBL*).
To know more about the Detector filter system, filter types, and filter
configuration refer to
Chapter 6, “Filter Procedures” for further details.