Cisco OL-6109-01 - Manual (Page 3)

4-3
Cisco Traffic Anomaly Detector User Guide
OL-6109-01
Chapter 4 Zone Configuration
Basic Zone Configuration
Note If no zone template is specified, the zone will be defined using
the Detector DEFAULT zone template.
– base-zone-name
—(Optional) The name of a desired zone used as a
template for the new zone.
– interactive
—(Optional) The operation mode of the new zone is set to
interactive (see the “Interactive Recommendations Mode” section for
further details).
Note Choosing Enter without specifying the zone template defines a zone
by the Detector default zone template.
2. Choose ENTER. Below is an example of the zone command implementation:
admin@DETECTOR-conf# zone scannet
admin@DETECTOR-conf-zone-scannet#
Duplicating a Zone
The user may duplicate a desired zone and define a new, identically- configured,
zone.
To duplicate a zone from the Configuration command group level perform the
following:
1. From the Configuration command group level type the following:
admin@DETECTOR-conf# zone <new-zone-name> copy-from
<base-zone-name>
Where:
– new-zone-name
—A zone name string. An alphanumeric string should
start with a letter, hold no spaces, and should be limited to a length of up
to 63 characters. The string may contain underscores.
– base-zone-name
—The name of a desired zone used as a template for the
new zone.