Cisco OL-6109-01 - Manual (Page 7)

4-7
Cisco Traffic Anomaly Detector User Guide
OL-6109-01
Chapter 4 Zone Configuration
Basic Zone Configuration
Where zone-name specifies the desired zone name.
2. Choose ENTER. Below is an example of the zone command implementation:
admin@DETECTOR-conf# zone scannet
admin@DETECTOR-conf-zone-scannet#
Describing a Zone
The user may add a description to a zone for identification purposes.
To add a description to a zone perform the following:
1. From the Zone command level type the following:
admin@DETECTOR-conf-zone-<zone-name># description <string>
Where
string
specifies a string that describes the zone. The string length is
limited to a maximum of 80 characters.
2. Choose ENTER. Below is an example of the description command
implementation:
admin@DETECTOR-conf-zone-scannet# description Scannet Zone used
for demonstration purposes
admin@DETECTOR-conf-zone-scannet#
Note To modify a zone’s description repeat the zone description procedure. The new
description overrides the former.
Defining the Zone IP Address
The user must define a zone IP address to enable the Detector to perform traffic
learning and detection procedures.
To define the zone IP address perform the following:
1. From the Zone command level type the following:
admin@DETECTOR-conf-zone-<zone-name># ip address <ip-addr>
[<ip-mask>]
Where:
– ip-addr —The zone IP address.