Cisco Cisco Unified Wireless IP Phone 7921G User Manual

Page 74

Advertising
background image

66

OL-16131-01

Tip

If you unplug the headset or remove the phone from the desktop charger, the phone reverts to the
speaker mode for features that typically use the speakerphone for incoming calls, such as AutoAnswer
or intercom calls.

Switch to the desktop charger
speakerphone

1.

Place the wireless IP phone in the desktop charger cradle. 
“AC connected!” displays on the screen.

2.

Press down on the top of the phone. 
“Docking connected!” displays on the screen and the

icon

displays on the phone status line.

The desktop charger speaker and microphone are connected.

3.

Place and receive calls.

Use all the buttons on your phone, including

and

.

You can use the headset to answer calls when the phone is in the
desktop charger.

Note

The internal, single-direction microphone is located on the lower
left side of the phone (two small holes). For best results, place
the desktop charger in front of you when using the
speakerphone.

Switch to the handset from
the desktop charger
speakerphone

1.

Hold the top of the phone and move it forward before lifting it
off the desktop charger.

2.

Use the handset to continue with the call. The desktop charger
speaker and microphone disconnect.

Note

You cannot turn off the desktop speaker by using the

button.

Adjust the volume level for a
call

During a call, press

to adjust the volume for the handset, speaker,


headset, or desktop charger.

Note

The new volume level is preserved for future calls after the
phone is powered off.

If you want to...

Then...

Advertising