Origin Live Solicore S Instructions & Cable End Joining - Manual

INSTRUCTIONS FOR SOLI-CORE END JOINTING
1) Cut wire to required length if necessary
2) Strip off the black outer sheath from each end to a length of approximately 80mm.
OUTER SHEATH
2 FOIL WRAPPED CORES
80mm
(3) Cut off the exposed string ends and strip off the aluminium foil from the exposed ends.
(4) Wind the exposed thin red enamel wires round the particular pair of thick wires they are
associated with. just to keep them tidy. Do not connect them to the thick wires as this is entirely
unnecessary. The cable is extraordinary in that the thin wires do not need to be connected to fulfil
their function.
Strip the insulation off the red, blue, black and yellow wire ends to a length of approximately 40mm.
OUTER SHEATH
TWISTED CORES
40mm
80mm
(6) Twist the bared copper end of the blue wire as tightly an possible around the black wire bared
end, then similarly the yellow wire around the red wire end, (see below Diag, it is best to use pliers
to ensure the tightest contact). Repeat for each cable end in turn. It is important that you follow this
procedure exactly so that the red and black wires are effectively the terminal wires (i.e. each red wire
is continuous from terminal to terminal and the black wire is continuous from terminal to terminal). If
your terminals are large enough to accept both wires, there is no need to leave only one wire for
connection.
OUTER SHEATH
YELLOW WIRE
TERMINAL RED WIRE
TERMINAL BLACK WIRE
BLUE WIRE
THIN WIRES (not connected)
The cable is now ready for connection into your system.