Cisco 4305G - Manual (Page 10)

10
Step 1 On the back of your DMP chassis, do one of the
following:
• If you will connect your DMP to a digital display
that has an HDMI interface, plug the male end of
the HDMI cable into the HDMI interface on
your DMP.
• If you will connect your DMP to one of the
recommended NEC display models that does
not have an HDMI interface, do all of
the following:
– Plug the male end of the HDMI cable into the
HDMI interface on your DMP, then connect an
HDMI-to-DVI adapter to the other end of your
HDMI cable.
– Plug the red jack on the RCA cable into the
AUDIO/RIGHT interface on your DMP.
– Plug the white jack on the RCA cable into the
AUDIO/LEFT interface on your DMP.