Tycon Power ENC-ST-23X14X12 - Manual

ENC-ST-23X14X12 Qwik Install
STEP 1: Add Grounding jumper wire between 2 copper studs and use copper wash-
ers and nuts to secure.
STEP 2: Install a hole plug in drain hole in bottom right corner of the enclosure.
STEP 3: Add wire feedthrus into the bottom connector
plate and attach the connector plate.
STEP 4: If pole mounting the enclosure, assemble the pole mount kit to the back of the enclosure and mount
the enclosure to a pole using 6 hose clamps (not included). The enclosure can also be wall mounted using the 4 holes in
the back of the enclosure.
STEP 5: Insert the battery platform in the bottom of the enclosure. The battery platform
has cutouts so wires can be routed under the battery as needed.