Appendix p: battery replacement, Overview, Replace the lithium battery – Cisco 4-Port SSL/IPSec VPN Router RVL200 User Manual

Page 109: Overview replace the lithium battery, Appendix p, Battery replacement

Advertising
background image

0

Battery Replacement

4-Port SSL/IPSec VPN Router

Appendix P

Appendix P:

Battery Replacement

Overview

The Router has a lithium battery, type CR2032, on its

main circuit board. This battery has an operating life of

approximately 1 to 2 years. When the battery loses its

charge, the Router cannot update its time setting unless

it is connected to an NTP server.

WARNING:

The lithium battery can explode if

it is replaced incorrectly. The battery must be

replaced with the same or equivalent type of

CR2032 lithium battery.

Replace the Lithium Battery

NOTE:

To replace the battery, the top case of

the Router must be removed. Disassembling

the Router will void its warranty; however, the

battery’s operating life is longer than the one-

year warranty of the Router.

To replace the battery, follow these instructions:

Obtain a replacement CR2032 lithium battery.
Power off the Router.
Remove the four rubber feet from the bottom panel

of the Router.
Remove the four screws that were located underneath

the rubber feet.
Remove the top case of the Router.
Remove the old CR2032 lithium battery.
Insert a new CR2032 lithium battery or its equivalent

type.
Replace the top case of the Router.
Replace the four screws on the bottom panel of the

Router.
Replace the four rubber feet.

1.
2.
3.

4.

5.
6.
7.

8.
9.

10.

Advertising