Cisco 4-Port SSL/IPSec VPN Router RVL200 - Manual (Page 32)

Chapter 4 Advanced Configuration
4 4-Port SSL/IPSec VPN Router
System Management > IGMP Snooping
Enable IGMP Snooping Select this option to use IGMP
Snooping.
Timeout Enter the time interval during which IGMP
broadcast packets from the IGMP server are sent to the
IGMP clients behind a specific port of the Router. If the time
interval has past, IGMP broadcast packets are broadcast to
all ports of the Router. After the timeout, the time interval
will restart if the Router receives IGMP broadcast packets
that need to sent to the IGMP clients. The default is 48
seconds.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
Port Management > Port Setup
Configure the connection settings for each local port,
such as priority, speed, and duplex. You can also enable or
disable the auto-negotiation feature for all ports.
Port Management > Port Setup
Basic Per Port Config.
The Basic Per Port Config. table displays the following:
Port ID The port number or name is displayed.
Interface The port’s interface type, LAN or WAN, is
displayed.
Disable To disable a port, select Disable.
Speed Select the port speed, 0M or 00M.
Duplex Select the duplex mode, Half or Full.
Auto Neg. Select Enable if you want the Router’s ports
to auto-negotiate connection speeds and duplex mode;
then you will not need to set up speed and duplex settings
separately.
Click Save Settings to save your changes, or click Cancel
Changes to undo them.
Port Management > Port Status
Status information is displayed for the selected port.
Port Management > Port Status
Port ID To see the status information and settings for a
specific port, select its ID number or name.
Port Status
Summary
For the selected port, the Summary table displays the
following:
Type The port type is displayed.
Interface The interface type, LAN or WAN, is displayed.
Link Status The status of the connection is displayed.
Port Activity The status of the port is displayed.
Speed Status The speed of the port, 10 Mbps, or 100
Mbps, is displayed.
Duplex Status The duplex mode is displayed, Half or
Full.
Auto negotiation The status of the feature is displayed.
Statistics
For the selected port, the Statistics table displays the
following: